Hunter Low Profile Plus - 42" Manuel d'installation télécharger pdf (Page 9)

42888-01 • 03/01/10 • Hunter Fan Company

All wiring must be in accordance with national and local electrical

codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a

qualiﬁed electrician.

Wall switches are not included. Select an acceptable general-use switch

in accordance with national and local electrical codes.

4-1. Before attempting installation, make sure the power is still o.

4-2. To connect the wires, hold the bare metal leads together and place

a wire connector over them, then twist clockwise until tight. For

all these connections use the wire connectors provided.

4-3. Connect the bare or green ground wire (grounding) from the

ceiling to the green ground wire (grounding) from the ceiling plate

and the green ground wire (grounding) from the fan.

4-4. Connect the white wire (grounded) from the ceiling to the white

wire (grounded) from the fan.

4-5. Connect the remaining wires as follows:

Dual Switch Wiring:

• e black wire (ungrounded) from the ceiling to the black wire

(ungrounded) from the fan

• e black wire with a white stripe (ungrounded) from the fan

to the wire (ungrounded) for the wall switch

Single Switch Wiring:

• e black wire (ungrounded) from the ceiling to the black

(ungrounded) and the black wire with a white stripe

(ungrounded) from the fan

CAUTION: Be sure no bare wire or wire strands are visible after

making connections.

4-6. Turn the splices upward and push them carefully back through the

ceiling plate into the outlet box.

4-7. Spread the wires apart, with the grounded wires on one side of

the outlet box and the ungrounded wires on the other side of the

outlet box.

Wire

Connector

4 •Wiring the Fan

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Hunter Low Profile Plus - 42" Manuel d'installation Page 9