Hunter 23252 44 Baseball Fan Manuel d'utilisateur télécharger pdf (Page 5)

41081-01 • 09/05 Hunter Fan Company

2 • Installing the Hanger Bracket

2-1. Drill two pilot holes into the wood support structure through

the outermost holes in the outlet box, using the ceiling plate as a

guide. e pilot holes should be 9/64” in diameter.

2-2. Install one screw into each side of the ceiling plate as shown.

2-3. Place a at washer on each of the two 3” screws.

2-4. read the lead wires from the outlet box down through the

hole in the middle of the ceiling plate.

2-5. Align the slotted holes in the ceiling plate with the pilot holes

you drilled in the wood support structure. If you are installing

the fan on an angled ceiling, be sure the hook on the ceiling

plate is pointing towards the ceiling peak.

2-6. Pass the screws through the slotted holes in the hanger bracket

into the pilot holes you drilled.

Tighten the screws into the 9/64” pilot holes; do not use

lubricants on the screws. Do not over tighten.

Flat Washer

3” Screw

For Angled Ceilings: Be sure to

orient the ceiling plate with the hook

pointing towards the ceiling peak.

Step 2-5 (Angled Ceiling Only)

Step 2-2

Step 2-1

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Hunter 23252 44 Baseball Fan Manuel d'utilisateur Page 5